recently i have found some time to play around with the zynthian and it sounds great and is a lot of fun.
One thing though i am not sure of is, does it have a working touch display or is everything done via the encoders?
Cause so far i have not found one situation where the screen would have responded to touch.
Settings in the webconf for Display is PiScreen 3.5(v2)
config details are:
""“
dtoverlay=piscreen2r-notouch,rotate=270
dtoverlay=ads7846,speed=2000000,cs=1,penirq=17,penirq_pull=2,swapxy=1,xohms=100,pmax=255
"”"
when looking at cat /dev/input/event0 and trying to use touch input nothing shows up and the zynthian itself does not respond to anything either.
I am using the separators that came with the bundle and loosening them a little does not change anything either.
I was using the latest image, but downloaded that again and did a fresh install with the same results…
Did everything. Unplugged and replugged the ribbon cable. Did update again. Still the same. No reaction to touch and no output from cat /dev/input/event0 in the console.
I have tried to reconfigure from webconf just now. Does not change anything though.
I don’t think i reversed the ribbon cable during initial putting together. The display did show the splash screen from the beginning on.